DENTSPLY 57H User Manual download pdf (Page 11)

DIE RELEASE APPLICATION

. Be sure the die margin is clean.

. Using DENTSPLY Prosthetics die release, apply a thin even layer of die release over the

margin area. Blow off the excess die release.

. Apply and allow to dry several more times until the die has a very slight sheen.

Die Release Application

FIRST MARGIN APPLICATION

. Place a small amount of the shaded margin porcelain on a clean palette.

. If modifier is necessary, add the modifier porcelain to the shaded margin porcelain.

. Mix the Ceramco Improved Margin and Opaque Correction Liquid with the Improved

Margin Porcelain to a thick creamy consistency. This mixture will air harden in approxi-

mately  minutes. If additional working time is required, mix in a small amount of

distilled water.

. Place the porcelain mixture in the gingival area, pushing the mixture down to but not

over the gingival margin. Do not over build.

First Shoulder Application

Note: All porcelains shrink by volume. The larger the porcelain mass the more apparent

the firing shrinkage. Better results are achieved by applying a small amount of porcelain

on the first porcelain application.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 116 117

No comments

DENTSPLY 57H User Manual Page 11